QUALITY & SERVICE

From Acceptance Test to Production Support

What is verified before a machine leaves the factory, what arrives with it, and how support continues afterwards.

BEFORE SHIPMENT

Acceptance Testing

01

Incoming Component Inspection

Machined parts, servo and drive components, pneumatic items and electrical parts are checked against drawing tolerance before assembly.

02

Assembly and Alignment

Station alignment, ball-screw and guide adjustment, and wiring are verified against the electrical diagram and assembly drawing.

03

Run and Sample Test

The machine is run with your wire, terminal and seal samples where supplied. Crimp height, pull-test results and processed parts are recorded.

04

Acceptance and Packing

The result is documented in a factory acceptance record, then the machine is cleaned, rust-protected and packed for sea freight.

DOCUMENTATION

What Arrives With the Machine

  • Operation manual with parameter setup and job change procedure
  • Electrical schematic and pneumatic circuit diagram
  • Spare-parts list with recommended stock items
  • Factory acceptance record and sample test data
  • Packing list, foundation and lifting notes issued before shipment

Documentation language follows the ordered configuration. Additional copies for a second shift or a maintenance team can be supplied on request.

Electrical configuration and compliance

Machines are built for the voltage, frequency and control-language requirements of the destination market. Where the ordered configuration requires a declaration or test file for the destination country, that document is supplied with the machine and named in the quotation. Because requirements differ by market and by machine type, the applicable documents are confirmed per order rather than listed as a general claim.

Machine assembly and testing area

AFTER DELIVERY

Service Scope

01

Commissioning Support

Remote guidance on installation checks, parameter setup and first production runs; on-site commissioning available for new lines.

02

Operator Training

Job change, tooling replacement, crimp-height adjustment and daily checks, delivered on site or by remote session.

03

Remote Diagnostics

Control-log review, fault reading and parameter correction over a remote session, with MES-ready machines able to export production records.

04

Spare Parts and Modification

Wear parts, applicators and die sets, plus machine modification when a terminal family or process changes.

Warranty

Warranty period, covered components and response commitments are stated in the supply agreement. They are set per machine type and destination rather than published as a single figure, because electrical configuration, duty cycle and operating environment differ between projects. Wear parts and tooling consumed in normal production are handled under the spare-parts terms.

For a specific warranty and service proposal, send the machine model, application and destination country through the enquiry form.

WhatsApp